Specifications

SSR 8000/8600 Getting Started Guide 19
Chapter 1: Features Overview
The SSR 8600 DC power supply has a five-terminal wiring block on the front panel,
consisting of two positive(+) terminal, two negative(-) terminal and a safety ground. The
DC supply is designed to be powered by a 48 Volt DC source.
DC Power Supply Specifications
The following table lists the physical specifications for the SSR’s DC Power Supplies.
The following table lists the environmental specifications for the SSR’s DC Power
Supplies
Switching Fabric Module (SSR 8600 only)
On the SSR 8600, the switching fabric is contained on a separate plug-in module. The SSR
8600 has slots for two of these modules. When two switching fabric modules are installed,
the module in the slot labelled “Fabric 1” serves as the primary switching fabric module,
and the module in the slot labelled “Fabric 2” serves as a redundant switching fabric
module.
Figure 8 shows the front panel of the SSR 8600 Switching Fabric module.
Figure 8. Front panel of SSR 8600 Switching Fabric Module
SSR 8000 SSR 8600
Dimensions 11.00" (L) x 7.70" (W) x 2.55" (H) 12.15" (L) x 7.70" (W) x 5.05" (H)
Weight 6.5 lbs. (2.95 kg) 12.0 lbs. (5.45 kg)
Power Output 300 W 600 W
Voltage Range 36-72V, 14 A @ 48 V nominal 36-72V, 27 A @ 48 V nominal
Operating Temperature +5° to +40°C (41° to 104°F)
Non-operating
temperature
-30° to +73°C (-22° to 164°F)
Operating Humidity 15% to 90% (non-condensing)
SSR-SF-16
Switching Fabric
Active
Online
Swap
Hot
Offline