Specifications

SSR 8000/8600 Getting Started Guide 49
Chapter 1: Features Overview
Dual HSSI Line Card
The Dual HSSI line card contains two 50-pin High Speed Serial Interface (HSSI) ports.
Figure 26 shows the front panel of the Dual HSSI WAN line card.
Figure 26. Front panel of Dual HSSI WAN line card
Cabling and Connector Specifications
The following table lists the media specifications for the Dual HSSI line card.
LEDs
The Dual HSSI line card uses the following LEDs.
Port Type Specification
HSSI • HSSI rev 2.11
• 50-pin High Speed Serial Interface (HSSI) connector; see “Dual
HSSI Line Card” on page 79 for pin assignments
• Recommended 3 meters (10 feet) segment length for standard WAN
line card-to-CSU/DSU data port.
1
1. Connector cables for WAN line cards may be ordered from Cabletron Systems. For detailed
information, including part numbers, see “Dual HSSI Line Card” on page 79.
LED Description
Offline When lit, this amber LED on the left side of the line card indicates
that the line card is offline (powered off) but is ready for hot swap.
The Offline LED also is lit briefly during a reboot or reset of the SSR
but goes out as soon as the Control Module discovers the line card.
Online When lit, this green LED indicates that the line card is online and is
ready to receive, process, and send packets if configured to do so.
Tx
Rx
Link
Dual HSSISSR-HSSI-02
Tx
Rx
Link
Online
Offline
Hot
Swap