Specifications

Chapter 2: Hardware Installation
56 SSR 8000/8600 Getting Started Guide
b. Use the #2 Phillips-head screwdriver and two of the supplied Phillips-head
screws to attach the mounting bracket to the chassis.
c. Attach the other mounting bracket.
2. Along with an assistant, lift the chassis into place in the mounting rack.
3. While your assistant holds the chassis in place, use the #2 Phillips-head screwdriver
and four #2 Phillips-head screws to attach the mounting brackets to the mounting
rack.
Note: Make sure there are at least 3 inches (7.62 centimeters) of room above and behind
the unit for air flow to the cooling fans.
Caution
: Make sure the screws are tight before your assistant releases the chassis. If you
accidentally leave the screws loose, the chassis can slip and fall, possibly becoming
damaged.
Installing an AC Power Supply
The primary AC power supply is shipped separately from the SSR chassis. To install or
replace the primary AC power supply or if you want to install a redundant power supply,
use the following procedure. You will need a #2 Phillips-head screwdriver to perform this
procedure.
Note: Use a single-phase grounded power source located within 6 feet (1.89 meters) of
the installation site.
AC Power Supply Specifications
The following table lists the physical specifications for the SSR’s AC Power Supplies.
SSR 8000 SSR 8600
Dimensions 11.00" (L) x 7.70" (W) x 2.55" (H) 12.15" (L) x 7.70" (W) x 5.05" (H)
Weight 6.5 lbs. (2.95 kg) 12.0 lbs. (5.45 kg)
Power Output 300 W 600 W
Voltage Range 100-125V, 5A
200-240V, 3A
100-125V, 10A
200-240V, 6A
Frequency 50-60 Hz 50-60 Hz