Specifications

Chapter 2: Hardware Installation
58 SSR 8000/8600 Getting Started Guide
3. Slide the AC power supply all the way into the slot, firmly but gently pressing to
ensure that the pins on the back of the power supply are completely seated in the
backplane.
4. Use the #2 Phillips-head screwdriver to tighten the captive screws on each side of the
power supply to secure it to the chassis.
5. Attach the power cable to the AC power supply.
Installing a DC Power Supply
The SSR DC power supply delivers 3.3, 5, and 12 volts DC to the SSR’s Control Module(s),
fan modules, and other components. A single DC power supply provides enough current
to operate a fully-configured chassis.
SSR 8000 DC Power Supply
Figure 29 shows the front view of an SSR 8000 DC power supply.
Figure 29. Front View of an SSR 8000 DC Power Supply
The SSR 8000 DC power supply has a three-terminal wiring block on the front panel,
consisting of a positive(+) terminal, negative(-) terminal and a safety ground. The DC
supply is designed to be powered by a 48 Volt DC source. 12 to 14 gauge wire should be
used to connect the 48 Volt source to the SSR 8000 DC power supply. 12 to 14 gauge wire
should also be used for the safety ground.
SSR-PS-8-DC
PWR
SN
!
To be installed in a restricted
access area in accordance
with the NEC or authority
having jurisdiction.
See manual for installation
instructions.
48/60V
14A MAX