Specifications

SSR 8000/8600 Getting Started Guide 65
Chapter 2: Hardware Installation
5. Store the DIMMs in an ESD-safe bag or other container and put them in a safe place.
6. Insert the new DIMMs in the slots, making sure that the contacts are fully inserted
downward into the connector slot.
7. Install the upgraded Control Module back into the chassis. (See “Installing the
Control Module” on page 63.)
Installing the Switching Fabric Module (SSR 8600 only)
On the SSR 8600, the switching fabric module is shipped separately from the SSR chassis.
To install or replace the primary switching fabric module, or if you want to install a
redundant switching fabric module, use the following procedure. You will need a #2
Phillips-head screwdriver to perform this procedure
The primary switching fabric module must be installed in slot Fabric 1. The redundant
switching fabric module must be installed in slot Fabric 2.