Specifications

Chapter 2: Hardware Installation
66 SSR 8000/8600 Getting Started Guide
Figure 36 shows an example of how to install a switching fabric module. The procedure
following the figure describes how to do this.
Figure 36. Installing a switching fabric module on the SSR 8600
To install a switching fabric module:
1. If a cover plate is installed over the switching fabric module slot (slot Fabric 1 or
Fabric 2), use the #2 Phillips-head screwdriver to remove the cover plate.
2. Slide the switching fabric module all the way into the slot, firmly but gently pressing
to ensure that the pins on the back of the module are completely seated in the
backplane.
Note: Make sure the circuit card (and not the metal plate) is between the card
guides, as shown in Figure 34 on page 63. Check both the upper and lower
tracks.
6
4
2
7
5
3
CM/1
PS2PS1
CM
SSR-16
1000BASE-SX
12
10
8
13
11
9
14 15
Fabric 1
Fabric 2
SSR-CM-2 CONTROL MODULE
21
87654321
87654321
10/100BASE-TXSSR-HTX12-08
10/100BASE-TXSSR-HTX12-08
1000BASE-LXSSR-GLX19-02
87
6
5
4
3
21
100BASE-FXSSR-HFX11-08
21
1000BASE-LXSSR-GLX19-02 SSR-GSX11-02
1000BASE-SXSSR-GSX11-02
21
87654321
10/100BASE-TXSSR-HTX12-08
87654321
10/100BASE-TXSSR-HTX12-08
87
6
5
4
3
21
100BASE-FXSSR-HFX11-08
87654321
10/100BASE-TXSSR-HTX12-08
21
Switching Fabric
87654321
10/100BASE-TXSSR-HTX12-08
SSR-CM-2 CONTROL MODULE
87654321
10/100BASE-TXSSR-HTX12-08
87654321
10/100BASE-TXSSR-HTX12-08
PWR
SSR-PS-16
SN
100-125V~ 10A
200-240V~ 6A
50/60 Hz
TO REMOVE POWER TO
UNIT DISCONNECT ALL
POWER SUPPLY CORDS
PWR
SSR-PS-16
SN
100-125V~ 10A
200-240V~ 6A
50/60 Hz
TO REMOVE POWER TO
UNIT DISCONNECT ALL
POWER SUPPLY CORDS
Switching Fabric
SSR-SF-16
SSR-SF-16