Specifications

SSR 8000/8600 Getting Started Guide 79
Chapter 2: Hardware Installation
To attach the segment cables to your Quad Serial – C/CE line card:
1. Obtain one of the Cabletron connector cables described on page 77 and connect the
single LFH-60 high density connector to the SSR WAN interface you wish to use.
2. Plug the remote end of the connector for each port you wish to use into its respective
CSU/DSU data port.
Dual HSSI Line Card
The Dual HSSI line card uses a 50-pin High Speed Serial Interface (HSSI) connector to link
to a Channel Service Unit/Data Service Unit (CSU/DSU). Cabletron offers a 3 meter (10
foot) 50-pin HSSI connector cable (part number SSR-HSSI-CAB) to connect Dual HSSI
line cards to remote CSU/DSU modules.
The following table maps the pin assignments for Cabletron’s 50-pin HSSI connector for
the Dual HSSI line card.
Note: Because neither connector at the ends of the SSR-HSSI-CAB cable is keyed, you
can simply plug either end of the cable into either your Dual HSSI line card or the
remote HSSI CSU/DSU data port.
Pin Signal Pin Signal Pin Signal Pin Signal
1 GND 14 (reserved) 26 GND 39 (reserved)
2 RT+ 15 (reserved) 27 RT- 40 (reserved)
3 CA+ 16 (reserved) 28 CA- 41 (reserved)
4 RD+ 17 (reserved) 29 RD- 42 (reserved)
5 LC+ 18 (reserved) 30 LC- 43 (reserved)
6 ST+ 19 GND 31 ST- 44 GND
7 GND 20 (reserved) 32 GND 45 (reserved)
8 TA+ 24 (reserved) 33 TA- 46 (reserved)
9 TT+ 22 (reserved) 34 TT- 47 (reserved)
10 LA+ 23 (reserved) 35 LA- 48 (reserved)
11 SD+ 24 (reserved) 36 SD- 49 (reserved)
12 LB+ 25 GND 37 LB- 50 GND
13 GND 38 GND