User manual

CHAPTER 3: INSTALLATION
3-4 FOT-F3 USER’S MANUAL
2. Attach the female connector on the AUI cable to the AUI
port on the FOT-F3. If the power is on for the Ethernet
device, the PWR LED should be lit, indicating the
transceiver is receiving power from the device. Also, if the
SQE test is enabled, the SQE LED should be lit.
Figure 3-2 AUI Connection
If the PWR LED is not lit, perform the following steps:
a. Verify that the power is turned on for the device
attached to the FOT-F3.
b. Disconnect the AUI cable from the FOT-F3.
SLIDE LATCH
AUI CONNECTOR
0461-07
Slide Latch
AUI Port
AUI Connector