User`s manual

Installation
CTP100T USER’S MANUAL Page 3-5
6. Check that the PWR LED of the CTP100T adapter ➒ is on. This
indicates that the unit is receiving power.
If the PWR LED is off, perform the following steps until it turns on:
a. Ensure that the power supply ➎ is plugged in.
b. Ensure that the power cord ➍ is connected to the CTP100T
adapter ➒.
c. Ensure that the power outlet has power.
7. Check that the LNK LED on the CTP100T adapter is on. This
indicates that the link has been made. If the LNK LED is off,
perform the following steps until it turns on.
a. Ensure that the device attached to the twisted pair cable
segment is powered up.
b. Disconnect the RJ45 connector from the RJ45 port ➋ of the
CTP100T adapter ➒.
c. Check that the RJ45 connector at each end of the twisted pair
cable ➊ has the proper pinouts and that each connector is
crimped properly.
d. Using a continuity checker, verify the end-to-end cable
continuity at pins 1, 2, 3, and 6 for repeater devices such as
the TPMIM 22/24/32/34, MiniMMAC, or MRXI.
If a device (such as a transceiver that is not internally cross-
wired) is being used, verify the continuity between pins 1 and
3 and pins 2 and 6.