Installation guide

Remote Management
SSR-600 Installation Guide 1-3
1.1.4 LANVIEW LEDs
Cabletron Systems LANVIEW Status Monitoring and Diagnostics
System is a troubleshooting tool that helps in diagnosing power failures,
collisions, cable faults, and link problems. The LANVIEW LEDs are
located on the SSR-600 front panel.
1.1.5 RESET Button
The front panel RESET button reboots the SSR-600 and initializes the
processor. The RESET button is also used with the mode switches to clear
NVRAM.
1.1.6 Console Port
The console port of the SSR-600 is used to access software management
by a direct connection to the SSR-600. Command Line Interface (CLI) is
used to communicate with the SSR-600. Refer to Appendix A for the
pinouts of the console cable. Use the applicable Cabletron Systems
software manuals for further information on the management of the
SSR-600. Refer to Related Manuals in the Introduction.
1.2 REMOTE MANAGEMENT
The SSR-600 can be remotely managed with any third party SNMP
compliant network management packages.