Installation guide
Installing Options
SSR-600 Installation Guide 3-3
To remove the chassis cover, proceed as follows:
1. Disconnect the SSR-600 from the network as follows (if applicable):
a. Unplug the power cord(s) from the rear of the SSR-600 chassis.
b. Disconnect any network cables attached to the SSR-600.
2. Use a Phillips screwdriver to remove the four screws that attach the
chassis cover to the unit. (See Figure 3-1).
3. While facing the back of the unit, remove the chassis cover by pulling
the cover toward you, then up and off the chassis.
Figure 3-1 Removing the Chassis Cover
TIP
Before performing step b, mark any cables connected to the
SSR-600 according to their associated port numbers. This is
recommended for ease of reinstallation.
A) Removing the Cover Screws
B) Lifting the Cover Off
3032_04