Installation guide

Installing Options
SSR-600 Installation Guide 3-5
3.3.3 Installing Sliding WAN Physical Interface
Modules
The SSR-600 is capable of having up to two Sliding WAN Physical
Interface Modules (SWPIMs) installed into its chassis. Figure 3-3
indicates the ports in the SSR-600 into which the SWPIMs can be
installed.
Figure 3-3 WAN SWPIM Ports
Refer to the applicable SWPIM Installation Guide for information on how
to safely install an SWPIM in the SSR-600 to enhance the capabilities of
your SSR-600. After installing your SWPIM, refer to the applicable
software guide for information on how to configure the SWPIM to
connect it to the WAN. Refer to the Related Manuals section in the
Introduction.
Figure 3-4 Removing an Existing SWPIM
!
CAUTION
Failure to follow the procedures for installation in the indicated
documentation can result in damage to either the installed
option or the SSR-600.
RESET
PWR
CPU
LNK
STS
SPD/100
XMT
RCV
SPD/100
XMT
RCV
10/100 10/100
ETHERNET 1 ETHERNET 2
WIDE AREA 2WIDE AREA 1
TELCO TELCO
CONSOLE
SWPIM Installation Ports
3032_06
1098_19
Mounting
Screw
SWPIM