Installation guide

Chapter 3: Installation
3-6 SSR-600 Installation Guide
3.4 INSTALLING THE SSR-600
The SSR-600 may be installed on a tabletop, shelf or in a 19-inch rack.
Refer to Section 3.4.1 for information concerning a tabletop or shelf
installation. Section 3.4.2 describes the rackmount installation.
3.4.1 Tabletop and Shelf Installations
To install the SSR-600 on a tabletop or shelf, locate the SSR-600 within
seven feet of its power source with an unrestricted free surface area as
shown in Figure 3-5, and complete the following steps:
1. Locate the four rubber feet included with your SSR-600.
2. Peel the paper backing off the rubber feet, and adhere them to the
bottom of the SSR-600. Place one rubber foot near each of the four
corners of the SSR-600.
Figure 3-5 Tabletop or Shelf Installation
Continue the installation by connecting power as described in Section 3.5.
3.4.2 SSR-600 Rackmount Installation
The optional rackmount kit, part number SSR-600-RCK-KIT, is used to
install the SSR-600 in a standard 19-inch rack.
!
CAUTION
Before performing installation procedures, ensure that the
requirements outlined in Section 3.1, Guidelines for Installation,
are met.
WARNING
Before installing the SSR-600 into a rack, ensure that the rack
supports the device without compromising the stability of the
rack. Otherwise, personal injury and/or equipment damage
may result.
18 IN.
16 IN.
21 IN.
RESET
PWR
CPU
LNK
STS
SPD/100
XMT
RCV
SPD/100
XMT
RCV
10/100 10/100
ETHERNET 1 ETHERNET 2
WIDE AREA 2WIDE AREA 1
TELCO TELCO
CONSOLE
2012_07