Installation guide

Installing the SSR-600
SSR-600 Installation Guide 3-7
Rackmounting the SSR-600 requires the following steps:
• Attaching the rackmount brackets to the SSR-600
• Installing the SSR-600 in a 19-inch rack
3.4.2.1 Tools Required
• Phillips screwdriver
• Flat blade screwdriver
3.4.2.2 Materials Required
1. The following parts are included in the SSR-600 rackmount kit (see
Figure 3-6):
• rackmount brackets (2)
• 6-32 x 1/4 inch flathead screws (4)
Figure 3-6 SSR-600 Rackmount Hardware
!
CAUTION
Do not use screws other than those supplied with the SSR-600
to perform the following procedures. The wrong size screws
can cause electrical or physical damage to the device.
20121_12
Rear
Flanges
Front End
Rear
Flanges