Installation guide

Chapter 3: Installation
3-8 SSR-600 Installation Guide
3.4.2.3 Attaching the Rackmount Brackets
Proceed as follows to attach the rackmount brackets:
1. Locate the two rackmount brackets.
2. With the faceplate, or front of the SSR-600, towards you, align the
front of the bracket with the front of the SSR-600. Locate the slots that
align with the rear flanges of the bracket. See Figure 3-7.
3. Swing the front of the bracket out and insert the flanges into the slots.
If the front of the bracket does not line up with the front of the
SSR-600 and the screw holes when you swing it in to the SSR-600,
readjust the position until it does. See Figure 3-7.
Figure 3-7 Aligning the Brackets for Installation
4. Use two of the four 6-32 x 1/4 inch flathead screws to attach the
bracket along the top edge of the SSR-600. See Figure 3-8.
Figure 3-8 Installing the Rackmount Brackets
WIDE AREA 2WIDE AREA 1
TELCO TELCO
3032_02
Bracket Screw Holes
RESET
PWR
CPU
LNK
STS
SPD/100
XMT
RCV
SPD/100
XMT
RCV
10/100 10/100
ETHERNET 1 ETHERNET 2
WIDE AREA 2WIDE AREA 1
TELCO TELCO
CONSOLE
Screws (4)
Rackmount
Brackets (2)
2012_09