Installation guide

Software Conﬁguration

SSR-600 Installation Guide 3-13

Figure 3-12 Straight-Through Cable RJ45 Pinouts

d. Ensure that the twisted pair connection meets the dB loss and

cable specifications outlined in the Cabletron Systems Cabling

Guide. Refer to the Introduction for information on obtaining this

document.

If a link can not be established, contact Cabletron Systems. Refer to

Getting Help, in the Introduction, for details.

4. Repeat steps 1 through 3 above, for both connections, as needed.

3.6.2 Connecting SWPIMs to the WAN

Refer to the applicable Cabletron Systems SWPIM manual for

information on connecting any SWPIMs to the WAN that you have

installed into the SSR-600.

3.7 SOFTWARE CONFIGURATION

Refer to the applicable Cabletron Systems software manual to conﬁgure

the SSR-600. Refer to the Related Manuals list in the Introduction.

CAUTION

Do not connect any WAN cables without checking the

guidelines and insuring that the software set-up in the SSR-600

is complete. The WAN connection can be shut off by the phone

company if the SSR-600 is not set up properly.

TO TO

SSR600 Ethernet Port Other Device Port

RX+ 1 1 RX+

RX- 2 2 RX-

TX+ 3 3 TX+

TX- 6 6 TX-

RJ45 to RJ45

NOTE:

RX+/RX- and TX+/TX-

must share a common

color pair.