Installation guide

Switches
SSR-600 Installation Guide 4-5
4.2.1 Switch Function Procedure
These steps must be followed to use the switch function:
1. Remove power to the SSR-600.
2. Remove the cover of the SSR-600. Refer to Section 3.3.1.
3. Refer to Table 4-4 for a description of the switch functions.
4. Locate the switch bank in Figure 4-2. For the function you need, flip
the appropriate switch from one side to the other side. The initial state
of the switch does not matter.
5. Replace the cover.
6. Restore power to the SSR-600.
Figure 4-2 Switch Bank Layout
FRONT PANEL
ON
12
3
4
SWPIM
Slot
SWPIM
Slot
Fan
Fan
Fan
ON
12
3
4
Switch Bank