Installation guide

Chapter 9 Network Device Driver Options 157
These are the possible interrupt values:
Value Compatible Computers
2, 3, 4, 5 8086 and 8088 computer
3, 4, 5, 9 80286 and 80386 computer, 8-bit slot.
3, 4, 5, 9, 10, 11, 12, 14, 15 80286 and 80386 computer, 16-bit slot (Levels
10–14 are available only if the adapter is
ASSY 3410-03 revision A or later.)
ioaddress
Indicates the current I/O address jumper configuration of the network
adapter. This entry must match the adapter’s switch settings. Possible
values are 300, 310, 330, and 350.
maxtransmits
Specifies the number of transmit queue entries in this driver.
netaddress
Overrides the network address of the network adapter. Use this entry
only when there are duplicate addresses on the network. The value of
this entry is a hexadecimal string of 12 digits enclosed in quotation
marks, such as "02608C010001".
product_id
Identifies the specific adapter. The value of this entry is a string of up
to 36 hexadecimal digits (must be an even number). Refer to the IBM
Token-Ring architecture manual for more details. The default value
for this entry is 0110F0F0F0F0F0F0F0F0F0F0F0F0F0F0F0F0.
speed
Sets the computer’s clock to maximize data transfer between the
computer and the TokenLink adapter. You may have to experiment
with this entry to get optimal performance. When this entry is set
incorrectly, the TokenLink adapter sometimes does not run.
The value of this entry can be any of the following:
Value Meaning
6 Insert two wait states on the bus.
8 Insert one wait state on the bus.
10 Insert no wait states on the bus.