Installation guide

Chapter 9 Network Device Driver Options 193
Hughes Lan Systems 6130
Required entry:
• drivername = hls6130$ or hls6130n$
The following table summarizes the possible entries and values in the
[hls6130] section of the LAN Manager PROTOCOL.INI file:
Entry Units Range
Default
drivername ——
hls6130$ or hls6130n$
interrupt integer 2–3
3
iobase hex. 360, 368
368
Entries in the [hls6130] section of the LAN Manager PROTOCOL.INI
file have the following meanings:
drivername
Identifies the driver name of the network device driver. The base
portion of the filename, plus a digit when more than one adapter is
installed, is the drivername. The drivername is hls6130$ for the
first adapter, hls61302$ for the second adapter, and so on. More than
nine adapters are not supported.
interrupt
Indicates the interrupt level of the network adapter. The interrupt
level can be 2 or 3 and this entry must be in the PROTOCOL.INI file.
The jumpers on the adapter must match the interrupt entry. The
default setting is 3.
iobase
Specifies the I/O base addresses for the network adapter. The possible
addresses are 360 and 368. This entry must be in the
PROTOCOL.INI file, and the jumpers on the adapter must match the
I/O base entry.