Installation guide

Chapter 9 Network Device Driver Options 213
National Semiconductor EtherNODE
Required entry:
• drivername = ms2000$ or ms2000n$
This driver is for the following network adapters:
• Amplicard AC210/AT
• National Semiconductor EtherNODE *16AT
• National Semiconductor EtherNODE 16-AT3
• Networth EtherneXt 16-bit UTP adapter
• Novell NE2000
• Novell NE/2
The following table summarizes the possible entries and values in the
[ne2000] section:
Entry Units Range Default
drivername — — ms2000$ or ms2000n$
interrupt integer 2–5 3
iobase hex. 200H–3E0H 300H
Entries in the [ne2000] section have the following meanings:
drivername
Identifies the device driver name. The driver name consists of the base
portion of the filename, plus a digit if more than one adapter is
installed. The drivername is ms2000$ for the first adapter,
ms20002$ for the second, and so on.
interrupt
Indicates the interrupt level of the network adapter. The interrupt can
range from 2 to 5 inclusive.
iobase
Indicates the base I/O address for the network adapter. If this entry
does not match the adapter’s I/O address jumper settings, the driver
reports an error. Values range from 200H to 3E0H in increments of
10H. If multiple adapters are installed, the difference between the
values must be at least 20H.