Installation guide

214 Installation Guide for Clients
National Semiconductor Sonic EISA (DP83932EB)
Required entry:
• drivername = nseisa$ or nseisan$
The following table summarizes the possible entries and values in the
[nseisa] section of the LAN Manager PROTOCOL.INI file:
Entry Units Range Default
drivername — — nseisa$ or nseisan$
interrupt integer 5, 9, 10, 11 9
ioaddress hex. 1000–8000 4000
Entries in the [nseisa] section of the LAN Manager PROTOCOL.INI file
have the following meanings:
drivername
Identifies the device driver name. The driver name consists of the base
portion of the filename, plus a digit if more than one adapter is
installed. The drivername is nseisa$ for the first adapter, nseisa2$
for the second, and so on.
interrupt
Indicates the interrupt level of the network adapter. This value must
match the jumper setting on the adapter.
ioaddress
Indicates the base I/O address for the network adapter. If this entry
does not match the adapter’s I/O address jumper settings, the driver
reports an error. Values range from 1000H to 8000H, in increments
of 1000H.