Installation guide

Chapter 9 Network Device Driver Options 235
iobase
Indicates the base I/O address for the network adapter.
linkspeed
Configures the network adapter for either 4 MBPS or 16 MBPS data
transfer rate.
maxframesize
Specifies the size of the RECEIVE and TRANSMIT buffers, in bytes.
The maximum size of the buffers depends on the network speed
setting. The adapter allows a value of 4096 at the 4 MBPS setting and
17952 at the 16 MBPS setting.
maxreceives
Specifies the maximum number of receive buffers that can be queued
at one time.
maxrequests
Specifies the maximum number of outstanding general requests and
configures the size of the general request queue.
maxtransmits
Specifies the maximum number of transmits that can be queued by the
driver.
media
Configures the network adapter for either STP or UTP cable type.
netaddress
Overrides the burned-in-address of the network adapter. If this value
is specified, it must be enclosed in quotation marks, such as
"400001261835", and the first digit must be 4, 5, 6, or 7.
saen
Configures the network adapter’s SAEN function on the P1392. In
most cases, the SAEN should be enabled (on). If your system is not
completely ISA-compatible, however, you may need to disable the
SAEN.