Installation guide

Chapter 9 Network Device Driver Options 245
Racal-Datacom NI5210
Required entry:
• drivername = ni5210$
The following table summarizes the possible entries and values in the
[ni5210] section of the LAN Manager PROTOCOL.INI file:
Entry Units Range Default
basemem hex. C000–EC00 D0000
drivername — — ni5210$
iobase hex. 200–3F8 300
irq integer 2–7 2
maxmulticasts integer 0–16 10
maxreceives integer 1–6 3
maxtransmits integer 1–50 6
Entries in the [ni5210] section of the LAN Manager PROTOCOL.INI
file have the following meanings:
basemem
Indicates the base address of the shared memory on the adapter.
drivername
Identifies the device driver name.
iobase
Indicates the base I/O address for the network adapter.
irq
Indicates the interrupt level of the network adapter.
maxmulticasts
Specifies the number of multicast addresses that the driver supports.
maxreceives
Specifies the number of receives that can be queued simultaneously.
maxtransmits
Indicates the number of transmit chain commands that can be queued
simultaneously.