Installation guide

248 Installation Guide for Clients
Racore Computer Products
Required entries:
• drivername = rtr16lm$ or rtr16lmn$
• ioaddress=value
This driver is for the following network adapters:
• Racore M8113
• Racore M8114
• Racore M8115
The following table summarizes the possible entries and values in the
[rtr16lm] section of the LAN Manager PROTOCOL.INI file:
Entry Units Range Default
drivername — — rtr16lm or
rtr16lmn$
ioaddress hex. A00–A60 A20
maxtransmits integer 3–50 10
netaddress hex. 400000000000–7
FFFFFFFFFFF
—
noearlyrelease ———
numreceivebuffe
rs
integer 3–100 12
pseudodma ———
receivebuffersize integer 256–17960 4096
Entries in the [rtr16lm] section of the LAN Manager PROTOCOL.INI
file have the following meanings:
drivername
Identifies the device driver name. The driver name consists of the base
portion of the filename, plus a digit if more than one adapter is
installed. The drivername is rtr16lm$ for the first adapter,
rtr16lm2$ for the second, and so on.
ioaddress
Specifies the I/O address for the adapter. If this parameter is not
specified, the driver will search for an adapter at all I/O addresses
until one is found. This parameter is required when using more than
one Racore network adapter.
maxtransmits
Specifies the number of transmits that can be queued simultaneously
by the driver.