Installation guide

262 Installation Guide for Clients
Thomas Conrad Arcnet Adapters
Required entry:
• drivername = tccarc$
This driver is for the following network adapters:
• Thomas Conrad TC3045-CX
• Thomas Conrad TC6145
• Thomas Conrad TC6245
The following table summarizes the possible entries and values in the
[tccarc] section of the LAN Manager PROTOCOL.INI file:
Entry Units Range Default
drivername — — tccarc$
interrupt integer — 3
memorybase hex. C000–DC00 D000
microchannel —— —
Entries in the [tccarc] section of the LAN Manager PROTOCOL.INI file
have the following meanings:
drivername
Identifies the driver name of the network device driver.
interrupt
Indicates the interrupt level of the network adapter. The interrupt
level can be 2/9, 3, 4, 5, 6, 7, 10, 11, 12, 14, or 15. The default
setting is 3.
memorybase
Indicates the base I/O address for the network adapter. If this entry
does not match the adapter’s I/O address jumper settings, the driver
reports an error. Values range from C000H to DC00H in increments
of 400H.
microchannel
Denotes the use of a TC6246 Arcnet network adapter.