Installation guide

266 Installation Guide for Clients
Ungermann-Bass UBNEI
Required entries:
• adaptertype = NIUpc, NIUpcPlus, NIUps, PCNIU, or PCNIUex
• drivername = ubnei$ or ubnein$
The following table summarizes the possible entries and values in the
[ubnei] section of the LAN Manager PROTOCOL.INI file:
Entry Units Range
Default
adaptertype ——
See explanation
drivername ——
ubnei$ or ubnein$
io_port hex. 0A20–1A20
0A20
irq_level — 2-7
5
maxmulticast — 0–255
0
maxrequests — 1–10
6
maxtransmits — 1–400
6
memorywindow hex. —
See explanation
receivebuffers — 16–512
64
receivebufsize bytes 256–1514
600
receivemethod ——
ReceiveLookahead
permanentaddr hex. 12 hex. digits
See explanation
slotnumber — 1–8
See explanation
Entries in the [ubnei] section of the LAN Manager PROTOCOL.INI file
have the following meanings:
adaptertype
Specifies the type of Ungermann-Bass network adapter installed on
the system. This field must be set to NIUpc, NIUpcPlus, NIUps,
PCNIU, or PCNIUex.
drivername
Identifies the driver name of the network device driver. The base
portion of the filename, plus a digit when more than one driver is
installed, is the drivername. The drivername is ubnei$ for the first
driver, ubnei2$ for the second, and so on.
io_port
Indicates the base I/O address for the network adapter. This entry
must match the adapter’s I/O address jumper settings. The entry is
ignored if adaptertype is NIUps.