Installation guide

276 Installation Guide for Clients
Western Digital TokenCard, TokenCard WS, and
TokenCard PLUS16
Required entry:
• drivername = tokwd$
This driver is for the following network adapters:
• Western Digital TokenCard (WD8005)
• Western Digital TokenCard WS (WD8005 WS)
• Western Digital TokenCard PLUS16 (WD8015)
The following table summarizes the possible entries and values in the
[tokwd] section of the LAN Manager PROTOCOL.INI file:
Entry Units Range Default
dma (TokenCard PLUS16
only)
— 5–7 5
drivername — — tokwd$
iobase hex. 0A20–3A20 0x0A20
irq — 2–15 3
maxrequests integer 6–64 8
maxtransmits integer 6–64 12
receivebuffers integer 6–96 12
receivebufsize bytes 256–1536 256
receivechains integer 6–96 12
Entries in the [tokwd] section of the LAN Manager PROTOCOL.INI
file have the following meanings:
dma (TokenCard PLUS16 only)
Specifies the DMA channel used by the network adapter. This entry
must match the adapter’s DMA jumper settings (two jumpers).
drivername
Identifies the driver name of the network device driver.
iobase
Indicates the base I/O address for the network adapter. This entry
must match the adapter’s I/O address jumper settings.
The value of this entry must be preceded by “0x” to show that it is a
hexadecimal number.