Installation guide

290 Installation Guide for Clients
2. Copy the .NIF files to the \MSLANMAN.xxx\DRIVERS\NIF
directory of the disk, where xxx is either DOS or OS2. For example, if
the disk were in the A drive and you were copying .NIF files for use
with MS-DOS, you would specify
A:\MSLANMAN.DOS\DRIVERS\NIF.
3. Copy the .XIF files to the \MSLANMAN.xxx directory of the disk,
where xxx is either DOS or OS2. For example, if the disk were in the
A drive and you were copying .XIF files for use with MS-DOS, you
would specify A:\MSLANMAN.DOS.
4. If only one directory (MSLANMAN.DOS or MSLANMAN.OS2) is
present, assign a volume label for the disk. The volume label is
DOS_DRV_xxx for a disk with files for use with MS-DOS or
OS2_DRV_xxx for a disk with files for use with OS/2, where xxx may
be any three characters and is optional.
Installing and Configuring Supplemental Drivers
After the drivers and driver-information files have been copied to the
supplemental drivers disk, the Setup program can install the new
drivers.
When LAN Manager is first installed, you can install network adapter
drivers from a supplemental drivers disk. When the Network Adapter
Drivers dialog box appears, choose the the Other Driver button button.
You can install protocols from a supplemental drivers disk. When the
Network Protocols dialog box appears, choose the the Other Protocol
button
If LAN Manager is already installed, you can install network adapter
drivers or protocols from a supplemental drivers disk using the
Configuration menu’s Network Drivers command. For installation
instructions, see Part 3 of this manual, “Managing Your LAN Manager
Software Configuration.”