Installation guide

46 Installation Guide for Clients
Installing an OS/2 Workstation
Using the LAN Manager installation disk set, install LAN Manager
onto a computer that already has OS/2 operating system software
installed. For workstation operating system and hardware requirements,
see Chapter 1, “
Introduction.
”
Û To install LAN Manager workstation software on a computer that
already has OS/2 installed
1. Start the computer and open an OS/2 window or full screen session.
2. Insert the LAN Manager OS/2 Setup disk into a disk drive. Make that
disk drive the current drive by typing driveletter: and pressing ENTER.
(Replace driveletter with the drive that contains the Setup disk.)
Caution Do not run the LAN Manager Setup program from
another drive (for example, by typing a:setup).
3. Start the installation process by typing setup and pressing ENTER.
If the computer has a monochrome or plasma screen, type setup
/mono and press ENTER.
4. Follow the on-screen instructions. If needed, you can access online
help for LAN Manager by choosing the Help button or by pressing F1.
Refer as necessary to the planning forms provided in Chapter 2,
“Planning for Installation and Configuration.”
5. At the end of the installation process, you will be instructed to reboot
the computer. Before you reboot, examine the PROTOCOL.INI file
in the LAN Manager directory (by default, \LANMAN) and verify
that it contains the proper values for your network configuration.
For configuration information, see Part 3, “Managing Your LAN
Manager Software Configuration.”
6. After you complete the installation, read “After Installing an OS/2
Workstation,” later in this chapter.
The LAN Manager workstation is now configured according to the
choices you made during the installation process. The CONFIG.SYS
(or CONFIG.OS2 for a dual-boot computer) and STARTUP.CMD files
are updated, and the old files are saved using numerical file extensions
(.00n).