Installation guide

Chapter 6 Managing an MS-DOS Workstation 65
2. Choose the Add New Config button.
The Network Adapter Drivers dialog box appears, displaying a
scrollable list of the available network adapter drivers. If necessary,
you can scroll through the list by clicking the scroll bar or by pressing
the PAGE DOWN and PAGE UP keys.
3. Select a network adapter driver.
• If the list contains the needed network adapter driver, select the
driver by clicking it or by pressing the UP and DOWN ARROW keys
until the driver is highlighted.
After the driver is selected, choose the OK button.
• If the list does not contain the needed network adapter driver, and
if you have a supplemental drivers disk containing that driver, you
can copy the driver to the computer by choosing the Other Driver
button and following the instructions that appear on your screen.
Copying a driver automatically chooses that driver for this new
configuration.
• Contact the manufacturer of your network adapter if you do not
have a needed network adapter driver.
When the network adapter driver is chosen using one of the above
procedures:
• If the selected network adapter driver is not monolithic, the
“Network Protocols” dialog box appears. Proceed to the next step.
• If the selected network adapter driver is monolithic, the
Workstation Configuration dialog box returns. Skip to step 7.