Installation guide

Chapter 6 Managing an MS-DOS Workstation 69
3. Choose the Remove Config button. The network device driver
configuration is removed.
4. Optionally, from the Workstation Configuration dialog box you can:
• Change the protocol(s) bound to a network adapter driver in a
network device driver configuration (as described earlier in this
section)
• Add a network device driver configuration (as described earlier in
this section)
• Return to step 2 and remove another network device driver
configuration
5. When you have completed your review (and your optional changes),
exit the Workstation Configuration dialog box.
• To exit this dialog box and discard any changes you made, choose
the Cancel button. The Setup screen returns. You are finished, and
steps 6 and 7 do not apply.
• To save any changes you made, choose the OK button. Depending
on this computer’s configuration and whether you made changes,
the TCP/IP Settings dialog box (step 6), the Configuration
Complete dialog box (step 7), or the Setup screen appears.
6. If the TCP/IP protocol is included in one of the configurations, and if
you chose the OK button in the Workstation Configuration dialog
box, the TCP/IP Settings dialog box appears: