Installation guide

Chapter 7 Managing an OS/2 Workstation

3. Optionally you can:

• Change the protocol(s) bound to a network adapter driver in a

network device driver configuration.

• Add a network device driver configuration.

• Remove a network device driver configuration.

Instructions for these optional tasks are provided following this

procedure.

4. When you have completed your review (and any changes you made in

step 3), exit the Workstation Configuration dialog box.

• To exit this dialog box and discard any changes you made in step

3, choose the Cancel button. The Setup screen returns. You are

finished, and steps 5 and 6 do not apply.

• To save any changes you made, choose the OK button. Depending

on this computer’s configuration and whether you made changes,

the TCP/IP Settings dialog box (step 5), the Configuration

Complete dialog box (step 6), or the Setup screen appears.

5. If the TCP/IP protocol is included in one of the configurations, and if

you choose the OK button in the Workstation Configuration dialog

box, the TCP/IP Settings dialog box appears:

Review or edit the TCP/IP Settings dialog box as necessary, and then

choose the OK button. If you made no changes, the Setup screen

returns and you are finished.