User`s guide

How to Change Community Names
Examples of Ways to Use ECM
10-10
Enterprise Configuration Manager
User’s Guide
3. In the Configurations window, manually create a configuration called
Ports1_2_OFF. When completed, the configuration should have the
following attributes, instance IDs, and values:
Attribute Value
rptrPortMgmtAdminState 2.1 1
rptrPortMgmtAdminState 2.2 1
rptrPortMgmtAdminState 2.3 2
rptrPortMgmtAdminState 2.4 2
..
..
..
The instance IDs (2.1,2.2, 2.3,2.4...) indicate that this board is located in
slot 2 and that there are 4+ ports on the board.
For this particular attribute, a value of 1 means OFF, a value of 2 means
ON. Therefore, this configuration will turn ports 1 and 2 off and ports 3
and 4 on.
4. In the Main window, select the configuration Ports1_2_OFF and click on
Load.
ECM loads the configuration to the MRXiRptr.
How to Change Community Names
ECM enables you to set or change the community name for a device. The
procedures in this section, show you how to change the community name of an
EMME from “Public” to “HP_Lan.”
1. In SpectroGRAPH, select an EMME icon and invoke ECM from it.
2. Manually create a configuration called NewCN. The completed
configuration should contain the following attribute and value:
Attribute Value
Community_Name HP_Lan
3. In the ECM Main window, select the configuration NewCN and click on
Load. ECM loads the configuration to the EMME you selected.
Remember that when you change the Community_ Name attribute in
ECM, you also need to change the SNMP community name on the device,
itself.
NOTE
Other devices may have different attributes to configure ports. For example,
the value 1 does not always mean OFF. Make sure you select the appropriate
attributes for the device type that you are working with.