Specifications

9031111 E7 Introduction

1-3

SPECTRUM Support

The following model type names refer to the models used to specify attributes,

actions, and associations for the EMME and EMM-E6 devices in SPECTRUM:

• HubCSIEMME (EMME)

• BRtrCSIEMM_E6 (EMM-E6)

Standard RMON (RMONApp) DLM (DLM_Agent) and Routing Services

(CtRouter) are also supported and may be purchased separately.

Modeling Instructions

It is recommended that you model all devices in SPECTRUM using the

AutoDiscovery. However, if you wish to model your device manually, follow the

steps below.

1. Model an EMME/EMM-E6. (Refer to How to Manage Your Network

with SPECTRUM for basic modeling instructions.)

2. Access the EMME/EMM-E6 Device Topology view to determine how many

repeater ports are being used on the backplane of this device.

3. For each repeater connection (Network A, B, or C) shown in the Device

Topology view, model a separate LAN icon (LAN_802_3) on the same

hierarchical level as the EMME/EMM-E6 device icon. (The names of the

LANs should correspond with the names of repeater ports they will be

connected to.)

4. Within the EMME/EMM-E6 Device Topology (DevTop) view, select File ->

Edit to enter the edit mode.

5. Highlight a single repeater icon.

6. Select Edit -> Copy.

7. Click OK in the conﬁrmation window to override the buffer.

8. Open the LAN model created in step 3 with name that corresponds with

the name of the repeater you copied in the previous step.

9. Enter the edit mode by selecting File -> Edit.

10. Select Edit -> Paste to paste the repeater icon into the LAN.

11. Select File -> Save and Close to complete the pasting process. The

off-page EMME/EMM-E6 icon (in shape of the triangle) should appear,

signifying the connection between the repeater and the EMME/EMM-E6

backplane.