Specifications

Device Events and Alarms
Event and Alarm Messages EMME/EMM-E6
4-6 Management Module Guide
CsEvFormat/Event000d0110
{d “%w- %d %m-, %Y - %T”} -
Error threshold exceeded. An error
threshold of {I 1}% good packets in
{I 5} seconds, exceeded on module in
slot {I 7}.
CsPCause/Prob000d0110
This threshold will indicate that a
malfunctioning device is present on this
module or that a cable fault exists. A
port level threshold should be set to
further troubleshoot to the offending
node.
CsEvFormat/Event000d0111
{d “%w- %d %m-, %Y - %T”} -
Collision threshold exceeded.
Collisions exceeded {I 1}% of good
packets in {I 3} seconds on the
module in slot {I 5} of {m} ({t}).
CsPCause/Prob000d0111
Collisions are caused by many nodes
contending for the network of cabling
faults. Use port level thresholds to
further troubleshoot to a device level.
CsEvFormat/Event000d0112
{d “%w- %d %m-, %Y - %T”} -
Traffic threshold, packets per
{I 3} seconds, exceeded on port {I 7}
on module in slot {I 5} of {m} ({t}).
CsPCause/Prob000d0112
The device(s) attached to this port may
have an application which requires a
large amount of network bandwidth. If
the application requires a large amount
of network bandwidth, then a bridge or
router could be used to logically
separate various network segments.
CsEvFormat/Event000d0113
{d “%w- %d %m-, %Y - %T”} -
Error threshold exceeded. An error
threshold of {I 1}% good packets in
{I 5} seconds, exceeded on port {I 9}
on module in slot
{I 7} of {m} ({t}).
CsPCause/Prob000d0113
The device(s) attached to this port could
have a hardware failure where it
transmits invalid packets or the cable
segment attached to this port may have
a problem. Check cable for loose
connection or continuity problems.
CsEvFormat/Event000d0114
{d “%w- %d %m-, %Y - %T”} -
Collision threshold exceeded.
Collisions exceeded {I 1}% of good
packets in {I 3} seconds on port
{I 7} on module in slot {I 5} of {m}
({t}).
CsPCause/Prob000d0114
The device(s) attached to this port may
have an adapter card problem which
causes them to transmit without
regarding network availability or a
cable problem may exist. Check adapter
card and cable for loose connections,
termination problems, or improper
pinouts.
Table 4-1. EMME/EMM-E6 Events and Alarms (Continued)
Message in the Event Log Alarm View Probable Cause
Message