Specifications

9031111 E7 Event and Alarm Messages
4-9
Device Events and Alarms
CsEvFormat/Event000d0121
{d “%w- %d %m-, %Y - %T”} - Board
Broadcast Threshold Exceeded.
CsPCause/Prob000d0121
This trap will be generated when the
broadcast (packets per time interval) has
been exceeded for the given module.
CsEvFormat/Event000d0122
{d “%w- %d %m-, %Y - %T”} - Port
Broadcast Threshold Exceeded.
CsPCause/Prob000d0122
This trap will be generated when the
broadcast (packets per time interval)
has been exceeded for the given port.
CsEvFormat/Event000d0125
{d “%w- %d %m-, %Y - %T”} -
System Voltage Low condition has
been detected by {m} ({t}).
CsPCause/Prob000d0125
The internal 5 volt line of the system is
low. The voltage low condition indicates
that either the power supplies are
failing or there is not enough power
available to the host modules. This is a
serious condition and should be
addressed immediately.
CsEvFormat/Event000d0126
{d “%w- %d %m-, %Y - %T”} -
System Voltage Normal condition
has been detected by {m} ({t}).
No Probable Cause Message
CsEvFormat/Event000d0127
d “%w- %d %m-, %Y - %T”} -
An EPIM has been removed from
port {I 3} on module in slot {I 1} of
{m} ({t}).
CsPCause/Prob000d0127
An Ethernet Port Interface Module
(EPIM) has been physically removed.
CsEvFormat/Event000d0128
{d “%w- %d %m-, %Y - %T”} -
An {T EPIMType 5} has been
inserted into port {I 3} on module in
slot {I 1} of {m} ({t}).
No Probable Cause Message
Table 4-1. EMME/EMM-E6 Events and Alarms (Continued)
Message in the Event Log Alarm View Probable Cause
Message