Specifications

9031732 E4 Event and Alarm Messages
4-7
TRMM-2/-4 Events and Alarms
CsEvFormat/Event00420208
{d “%w- %d %m-, %Y - %T”} - BEACON
STATE CLEARED - Device {m} of type
{t} reported that the last beacon of
type {T LstBcnType 1} has been
cleared. (event [{e}])
No probable cause message.
CsEvFormat/Event00420209
{d “%w- %d %m-, %Y - %T”} -
STATION ADDED - Device {m} of type
{t} reported that station {T 1} has been
added to the Allowed Station List.
(event [{e}])
No probable cause message.
CsEvFormat/Event0042020a
{d “%w- %d %m-, %Y - %T”} -
STATION REMOVED - Device {m} of
type {t} reported that station {T 1} has
been removed from the Allowed
Station List. (event [{e}])
No probable cause message.
CsEvFormat/Event0042020b
{d “%w- %d %m-, %Y - %T”} - RING
CONFIGURATION CHANGED -
Device {m} of Type {t} reported that its
ring configuration has changed. (event
[{e}])
No probable cause message.
CsEvFormat/Event0042020c
{d “%w- %d %m-, %Y - %T”} - PORT
REMOVED DURING FAULT
RECOVERY - Device {m} of type {t}
reported that port {I 1} in module {I 2}
was removed from the ring during a
fault recovery condition. (event [{e}])
CsPCause/Prob0042020c
PORT REMOVED DURING FAULT
RECOVERY SYMPTOMS:
A port was removed from the ring during a
fault recovery condition.
PROBABLE CAUSES:
1) Bad cable connected to removed port.
2) Device connection is bad at other end of the
cable.
RECOMMENDED ACTIONS:
1) Check cable connected to removed port.
2) Check device connection at other end of the
cable.
3) After problem is resolved, enable the
removed port.
Table 4-1. TRMM-2/-4 Events and Alarms (Continued)
Message in the Event Log
Alarm View Probable Cause
Message