Specifications

TRMM-2/-4 Events and Alarms
Event and Alarm Messages TRMM -2/ -4
4-8 Management Module Guide
CsEvFormat/Event0042020d
{d “%w- %d %m-, %Y - %T”} - BOARD
BYPASSED DURING FAULT
RECOVERY - Device {m} of type {t}
reported that module {I 2} was
bypassed during a fault recovery
condition. (event [{e}])
CsPCause/Prob0042020d
BOARD BYPASSED DURING FAULT
RECOVERY SYMPTOMS:
A module was bypassed during a fault
recovery condition.
PROBABLE CAUSES:
1) This module is configured with a different
ring speed than the hub.
RECOMMENDED ACTIONS:
1) Pull out the bypassed module from the
hub.
2) Re-configure this module’s ring speed to
match that of the hub.
3) Physically insert the module back into the
hub.
4) Set this module’s bypass state to inserted.
CsEvFormat/Event0042020e
{d “%w- %d %m-, %Y - %T”} - PORT
VIOLATION - Device {m} of type {t}
reported that port { I 1} in module {I 2}
has detected a link while the port’s
management state was disabled.
(event [{e}])
CsPCause/Prob0042020e
PORT VIOLATION SYMPTOMS:
A link has been detected for a port while its
management state was disabled.
PROBABLE CAUSES:
1) A physical connection has been made
between a station and a port while the port’s
management state was disabled.
RECOMMENDED ACTIONS:
1) If the station belongs on this ring, then
enable the port’s management state.
2) If the station does not belong on this ring,
then physically disconnect the intruding
station from the port.
CsEvFormat/Event0042020f
{d “%w- %d %m-, %Y - %T”} - PORT
VIOLATION CLEARED - Device {m}
of type {t} reported that port { I 1} in
module {I 2} has detected an unlink
while the port’s management state
was disabled. (event [{e}])
No probable cause message.
Table 4-1. TRMM-2/-4 Events and Alarms (Continued)
Message in the Event Log
Alarm View Probable Cause
Message