Owner`s manual
Table Of Contents
- Title Page
- Notice
- Contents
- Preface
- Hardware Overview
- Checking the Site
- Cabling the Site
- Connector and Cable Pin Descriptions
- Replacing and Adding Memory
- Replacing and Adding Flash RAM
- What to Do If You Have Problems
Hardware Overview
1-4
Table 1-3 describes the LEDs.
Table 1-4 describes the connectors. For additional information on the connectors,
refer to Chapter 4.
Table 1-3. Network Activity LED
Ethernet
Selected
Connection Status LED Display
10BaseT Open/incorrectly terminated OFF
Correctly terminated/no network activity ON
Correctly terminated/network activity Flashing (rate independent of
network activity).
Standard Open on network activity OFF
Correctly connected/no network activity OFF
Correctly connected/network activity Flashing or ON, depending
on network activity.
Table 1-4. Access Server 316 Connectors
Connector Description
Serial port connectors These 16 female MJ8 connectors connect asynchronous serial
devices to the Access Server 316.
Standard Ethernet
connector
This single 15-pin female D-connector connects to a standard
Ethernet/IEEE 802.3 local area network using a transceiver
cable.
10BaseT Ethernet
connector
This single female MJ8 connector connects to a 10BaseT
Ethernet/IEEE 802.3 local area network.
Power cord receptacle The Access Server 316 power cord plugs into this receptacle.