Owner`s manual
Table Of Contents
- Title Page
- Notice
- Contents
- Preface
- Hardware Overview
- Checking the Site
- Cabling the Site
- Connector and Cable Pin Descriptions
- Replacing and Adding Memory
- Replacing and Adding Flash RAM
- What to Do If You Have Problems
3-1
Chapter 3
Cabling the Site
This chapter shows you how to install the cables and associated devices used by
the Access Server 316.
This chapter includes the following sections:
• Preinstallation Checks
• Installing the Ethernet Cables and Devices
• Installing Serial Cables and Devices on the Access Server 316
• Cabling Requirements
• Installing the Access Server 316 in a Rack
• Installing the Access Server 316 on a Desktop
Preinstallation Checks
Before beginning the Access Server 316 installation, use the following checklist to
make sure that the site preparation is complete:
• Arrangements have been made to connect the Access Server 316 Ethernet port
to an Ethernet interface device (if required).
• The Ethernet interface device is installed and the required cabling is in place,
tested, and tagged.
• The rack-mount kit is installed (if required), as described in later in this chapter.
• Cables of appropriate length are available for connecting the Access Server 316
to the Ethernet interface device.
• The devices (terminals, modems, personal computers, hosts) are ready to be
connected.