Owner`s manual
Table Of Contents
- Title Page
- Notice
- Contents
- Preface
- Hardware Overview
- Checking the Site
- Cabling the Site
- Connector and Cable Pin Descriptions
- Replacing and Adding Memory
- Replacing and Adding Flash RAM
- What to Do If You Have Problems
5-9
Replacing and Adding Memory
8. Remove the anti-static kit.
9. Replace the cover (Figure 5-8).
Figure 5-8. Cover Replacement
10. Connect a terminal to the Access Server 316 (See section titled System OK LED
Flashing on page 7-4.).
11. Reconnect the cables and test the Access Server 316.
When you plug in the power cable, the Access Server 316 runs self-tests. After
the tests are completed, the Access Server 316 requests a load from Flash
RAM. If Flash RAM is installed, three horizontal segments will be displayed.
To abort Flash RAM load and to load from the network, press and hold the
system reset switch until the display flashes. The Seven-segment display will
alternate between 3 and 4 until the software is loaded from the network.
Allow 3 minutes for the Access Server 316 to complete the procedure.