Owner`s manual
Table Of Contents
- Title Page
- Notice
- Contents
- Preface
- Hardware Overview
- Checking the Site
- Cabling the Site
- Connector and Cable Pin Descriptions
- Replacing and Adding Memory
- Replacing and Adding Flash RAM
- What to Do If You Have Problems
6-9
Replacing and Adding Flash RAM
Example
Local> SHOW MEMORY CONFIGURATION
Dynamic RAM: 4M bytes
Non-Volatile RAM: 32K bytes
Flash RAM:
Installed: Yes
Total size: 4M bytes
Boot block: Valid
Load image:
Name: WWENG2
Size: 967756 bytes
Version: V2.3
Your Flash RAM can also be updated with the INITIALIZE command. This
command copies the load image to Flash RAM. For more information about the
SHOW MEMORY CONFIGURATION or the INITIALIZE command, refer to the
Network Access Software Management guide or Network Access Software Commands
guide.
If Flash RAM is installed, but its boot block is invalid, then the total memory size
will be displayed as zero.
NOTE