User Manual

Enterasys X-Pedition User Reference Manual 151
Configuration Examples
3. The interface on which router advertisement is enabled.
4. Multicast address.
5. Current values for the intervals between the sending of router advertisements and the lifetime
of addresses sent in a router advertisement.
6. IP address that is included in router advertisement. The preference of this address as a default
route is 0, the default value.
7. Shows configured values for the specified interface.
Configuration Examples
Assigning IP/IPX Interfaces
To enable routing on the XP, you must assign an IP or IPX interface to a VLAN. To assign an IP or
IPX interface named ‘RED’ to the ‘BLUE’ VLAN, enter the following command:
You can also assign an IP or IPX interface directly to a physical port.
Note: The XP supports a maximum of 64 IPX interfaces. Enterasys recommends that you use
alphabetic characters when defining interface names—purely numeric interfaces will be
interpreted as IP addresses. The XP will display interface names up to 32 characters in
length.
xp(config)# interface create ip RED address-netmask 10.50.0.1/255.255.0.0 vlan BLUE