User Manual

Enterasys X-Pedition User Reference Manual 177
Configuring RIP
To change RIP parameters, enter the following commands in Configure mode.
Authentication None
Update interval 30 seconds
Set RIP Version on an interface to
RIP V1.
rip set interface <interfacename-or-IPaddr>|all version 1
Set RIP Version on an interface to
RIP V2.
rip set interface <interfacename-or-IPaddr>|all version 2
Specify that RIP V2 packets
should be multicast on this
interface.
rip set interface <interfacename-or-IPaddr>|all type
multicast
Specify that RIP V2 packets that
are RIP V1-compatible should be
broadcast on this interface.
rip set interface <interfacename-or-IPaddr>|all type
broadcast
Change the metric on incoming
RIP routes.
rip set interface <interfacename-or-IPaddr>|all metric-in
<num>
Change the metric on outgoing RIP
routes.
rip set interface <interfacename-or-IPaddr>|all metric-out
<num>
Set the authentication method to
simple text up to 8 characters.
rip set interface <interfacename-or-IPaddr>|all
authentication-method simple
Set the authentication method to
MD5.
rip set interface <interfacename-or-IPaddr>|all
authentication-method md5
Specify the metric to be used when
advertising routes that were
learned from other protocols.
rip set default-metric <num>
Enable automatic summarization
and redistribution of RIP routes.
Note: The rip set auto-summary
command must be enabled if the
router will act as a border gateway
using RIP Version 1.
rip set auto-summary disable|enable
Specify broadcast of RIP packets
regardless of number of interfaces
present.
rip set broadcast-state always|choose|never
Check that reserved fields in
incoming RIP V1 packets are zero.
rip set check-zero disable|enable
RIP Parameter Default Value