User Manual

Configuring IPX Interfaces and Parameters
360 Enterasys X-Pedition User Reference Manual
Configuring IPX Interfaces and Parameters
This section provides an overview of configuring various IPX parameters and setting up IPX
interfaces.
Configuring IPX Addresses to Ports
You can configure one IPX interface directly to a physical port. To configure an IPX interface to a
port, enter the following command in Configure mode:
Note: The XP will display interface names up to 32 characters in length.
Configuring Secondary Addresses on an IPX Interface
You can configure secondary addresses on an IPX interface.
To configure a secondary address on an IPX interface, enter the following command in Configure
mode:
Note: Configuring a secondary address on an IPX interface requires updated XP hardware. The
XP will display interface names up to 32 characters in length.
Configuring IPX Interfaces for a VLAN
You can configure one IPX interface per VLAN. To configure a VLAN with an IPX interface, enter
the following command in Configure mode:
Note: A VLAN containing both LAN and WAN ports will not support interfaces configured
with IPX. The XP will display interface names up to 32 characters in length.
Configure an IPX interface to a
physical port.
interface create ipx <InterfaceName> address-mask
<ipxAddr-mask> port <port>
Add a secondary address and
encapsulation type to an existing
IPX interface.
interface add ipx <Interface Name> address <IPX-
network-address>
output-mac-encapsulation
<encapsulation-type>
Create an IPX interface for a
VLAN.
interface create ipx <InterfaceName>
address-mask
<ipxAddr-mask> vlan <name>