User Manual

Enterasys X-Pedition User Reference Manual 447
Limiting Traffic Rate
To define a VLAN rate limiting policy, enter one of the following commands in Configure mode:
Displaying Rate Limit Information
To show information about rate limit policies, use the following command in the Enable mode:
Note: The XP will display interface names up to 32 characters in length.
Define a VLAN rate limiting policy
to limit incoming or outgoing traffic
on a VLAN.
rate-limit <name> vlan <name> port <port list> |
all-ports destport <port list> |all-ports rate <num>
exceed-action drop-packets| set-priority-low|
set-priority-medium| set-priority-high
[burst-compensating] aggregate
Show rate limit policy information. rate-limit show [all] |[policy-type flow-policies|
flow-aggregate-policies| aggregate-policies|
portlevel-policies|all]| [policy-name <name>]|
[interface <interface>]| [port-level port <port list>|
all-port] | [port-level policy-name <name>]|
[rate-limiting-mode]