220S Series Commercial Grade SATA II SSD and Slim SATA Product Manual Cactus Technologies Limited Suite C, 15/F, Capital Trade Center 62 Tsun Yip Street, Kwun Tong Kowloon, Hong Kong Tel: +852-2797-2277 Email: sales@cactus-tech.com Cactus USA 3112 Windsor Road Suite A356 Austin, Texas 78703 Tel: +512-775-0746 Email: americas@cactus-tech.com Cactus-Tech.
The information in this manual is believed to be accurate at the time of publication but is subject to change without notice. Cactus Technologies® Limited shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use of this material.
CONTENTS Table of 1 . Introduction to Cactus Technologies 220S Series Commercial Grade SSD Products ................................................................................................................ 1 1.1.Supported Standards..................................................................................................................... 2 1.2.Product Features............................................................................................................................
CONTENTS Table of 6.1.S.M.A.R.T. Data Structure............................................................................................................ 21 6.2.S.M.A.R.T. Attributes..................................................................................................................... 22 Appendix A.Ordering Information............................................................................... 23 Appendix B.Technical Support Services......................................................
01 Introduction to Cactus Technologies 220S Series Commercial Grade SSD Products Features Overview • Solid state design with no moving parts • Available in industry standard 2.5" and 1.8' half-slim form factors • Capacities from 4GB to 128GB for half-slim and 16GB to 256GB for 2.5" • Compliant with Serial ATA 2.6 specifications • ATA-8 compatible • Supports Serial ATA Generation I/II transfer rate of 1.5/3.
1.1. Supported Standards Cactus Technologies SSD is fully electrically compatible with the following specification: • ATA 8 Specification published by ANSI • Serial ATA 2.6 Specification published by the Serial ATA International Organization 1.2. Product Features Cactus Technologies Commercial mSATA SSD contains a high level, intelligent controller.
1.2.3. Power Supply Requirements Cactus Technologies® Commercial SSD operates at a voltage range of 5.0 volts ± 10%. Cactus Technologies® 220S Series Commercial Grade SATA II SSD and Slim SATA Product Manual v2.
02 Product Specifications For all the following specifications, values are defined at ambient temperature and nominal supply voltage unless otherwise stated. 2.1. System Environmental Specifications Table 2-1. Environmental Specifications Temperature Humidity Operating: Operating & Non-Operating: Cactus Commercial SSD 0° C to +70° C (Standard) 8% to 95%, non-condensing 0 dB Acoustic Noise Vibration Operating & Non-Operating: 20G, MIL-STD-883G Method 2005.
2.3. System Performance All performance timings assume the drive controller is in the default (i.e., fastest) mode. Table 2-3. Performance Start Up Times Read Transfer Rate Reset to ready: 35 msec typical 4/8GB (single channel) Up to 35 MBytes/sec 16GB (dual channel) Up to 70 MBytes/sec 32GB and above (4 channels) Up to 165 MBytes/sec Write Transfer Rate 4/8GB (single channel) Up to 10 MBytes/sec 16GB (dual channel) Up to 20 MBytes/sec 32GB and above (4 channels) Up to 80 MBytes/sec 2.4.
2.5.1. 2.5" SSD Physical Specifications Figure 2-1. 2.5" SSD Dimensions Cactus Technologies® 220S Series Commercial Grade SATA II SSD and Slim SATA Product Manual v2.
2.5.2. 1.8" Half-Slim Physical Specifications Figure 2-2. 1.8" Half-Slim Dimensions Cactus Technologies® 220S Series Commercial Grade SATA II SSD and Slim SATA Product Manual v2.
Cactus Technologies® 220S Series Commercial Grade SATA II SSD and Slim SATA Product Manual v2.
Cactus Technologies® 220S Series Commercial Grade SATA II SSD and Slim SATA Product Manual v2.
03 Interface Description The following sections provide detailed information on the Cactus Technologies Commercial SSD interface. 3.1. SSD Pin Assignments and Pin Type Cactus Technologies® SSD uses industry standard 7+12 SATA connector. The signal/pin assignments and descriptions are listed in Table 3-5. Table 3-5.
3.2. Electrical Specification The following table defines all D.C. Characteristics for the SSD products. Unless otherwise stated, conditions are: Vcc = 5.0V ± 10% Ta = 0°C to 70°C 3.2.1. Absolute Maximum Ratings Parameter Symbol MIN MAX Units Storage Temperature Ts -40 +85 °C Operating Temperature TA 0 +70 °C Vcc with respect to GND Vcc -0.3 5.5 V Symbol MIN MAX Units Vin -0.5 Vcc + 0.5 V Vout -0.3 Vcc + 0.
04 ATA Drive Register Set Definition and Protocol The communication to or from the SSD is done using FIS. Legacy ATA protocol is supported by using the legacy mode defined in the SATA specifications. In this mode, the FIS has defined fields which provide all the necessary ATA task file registers for control and status information. The Serial ATA interface does not support Primary/Secondary or Master/Slave configurations.
4.1.4. Sector Count Register This register contains the number of sectors of data requested to be transferred on a read or write operation between the host and the SSD. If the value in this register is zero, a count of 256 sectors is specified. If the command was successful, this register is zero at command completion. If not successfully completed, the register contains the number of sectors that need to be transferred in order to complete the request. 4.1.5.
4.1.9. Status Registers These registers return the status when read by the host. Reading the Status register does clear a pending interrupt while reading the Auxiliary Status register does not. The meaning of the status bits are described as follows: D7 D6 D5 D4 D3 D2 D1 D0 BUSY RDY DWF DSC DRQ CORR 0 ERR Bit 7 (BUSY) The busy bit is set when the device has access to the command buffer and registers and the host is locked out from accessing the command register and buffer.
Bit 7 This bit is an X (Do not care). Bit 6 This bit is an X (Do not care). Bit 5 This bit is an X (Do not care). Bit 4 This bit is an X (Do not care). Bit 3 This bit is ignored by the drive. Bit 2 (SW Rst) This bit is set to 1 in order to force the drive to perform an AT Disk controller Soft Reset operation. The drive remains in Reset until this bit is reset to '0'. Bit 1 (-IEn) The Interrupt Enable bit enables interrupts when the bit is 0.
05 ATA Command Description This section defines the ATA command set supported by the Cactus Technologies® SSDs. 5.1. ATA Command Set Table 5-6 summarizes the supported ATA command set. Table 5-6.
COMMAND Code FR SC SN CY DH Security Disable Password F6h - - - - D Security Erase Prepare F3h - - - - D Security Erase Unit F4h - - - - D Security Freeze Lock F5h - - - - D Security Set Password F1h - - - - D Security Unlock F2h - - - - D Seek 7Xh - - Y Y Y Set Features EFh Y - - - D Set Max Address F9h - Y Y Y Y Set Max Address Ext 37h - Y Y Y D Set Multiple Mode C6h - Y - - D Set Sleep Mode E6h, 99h - - - - D SMART
5.1.1. Identify Drive-ECH The Identify Drive command enables the host to receive parameter information from the drive. This command has the same protocol as the Read Sector(s) command. The parameter words in the buffer have the arrangement and meanings defined in Table 5-7. All reserved bits or words are zero. Table 5-7 is the definition for each field in the Identify Drive Information. Table 5-7.
Word Address Default Value Total Bytes Data Field Type Information 64 0003H 2 Advanced PIO modes supported (modes 3 and 4) 65 0078H 2 Minimum MWDMA cycle time per word is 120ns. 66 0078H 2 Recommended MWDMA cycle time is 120ns. 67 0078H 2 Minimum PIO cycle time without IORDY flow control is 120ns. 68 0078H 2 Minimum PIO cycle time with IORDY flow control is 120ns.
Word Address Default Value Total Bytes Data Field Type Information 129-159 0000H 60 Vendor Specific 160 80FAH 2 CFA Power mode: no level 1, max. 250mA 161 8001H 2 CFast specific support: PHYSLP supported 162 0000H 2 CPRM not supported 163 0000H 2 CFA Advanced modes: not relevant for CFast 164-216 0000H 2 Reserved 217 0001H 2 Solid State Device 218-255 0000H 8 Reserved Cactus Technologies® 220S Series Commercial Grade SATA II SSD and Slim SATA Product Manual v2.
06 S.M.A.R.T. Feature Set Cactus Technologies® -220 Series SSD supports S.M.A.R.T. attribute reporting. This following subcommands are supported when programmed into the Feature Register: Value Command Value Command D0h Read Data D5h Reserved D1h Read Attribute Threshold D6h Reserved D2h Enable/Disable Autosave D8h Enable SMART operationes D3h Save Attribute Values D9h Disable SMART operations D4h Execute OFF-LINE Immediate DAh Return Status 6.1. S.M.A.R.T.
6.2. S.M.A.R.T.
Appendix A Ordering Information Model KDXF-220SM3 Where X is card capacities: 4G ...................................................................................................... 4GB (half-slim only) 8G ...................................................................................................... 8GB (half-slim only) 16G ............................................................................................................................ 16GB 32G .......................................
Appendix B Technical Support Services Cactus Technologies® Limited Suite C, 15/F, Capital Trade Center 62 Tsun Yip Street, Kwun Tong Kowloon, Hong Kong Tel: +852-27972261 Fax: +852-27973777 Email: tech@cactus-tech.com Cactus Technologies® Limited Santa Clara, CA 95054 Email: tech@cactus-tech.com Cactus Technologies® 220S Series Commercial Grade SATA II SSD and Slim SATA Product Manual v2.
Appendix C Cactus Technologies debra.park2 debra.park2zz z vzv v z Offices v Worldwide Sales ® z Cactus Technologies® Limited Suite C, 15/F, Capital Trade Center 62 Tsun Yip Street, Kwun Tong Kowloon, Hong Kong Tel: +852-27972277 Fax: +852-27973777 Email: sales@cactus-tech.com Cactus® USA 3112 Windsor Road Suite A-356 Austin, Texas Tel: +512-775-0746 Email: americas@cactus-tech.com Cactus Technologies® 220S Series Commercial Grade SATA II SSD and Slim SATA Product Manual v2.
Appendix D Limited Warranty I. WARRANTY STATEMENT Cactus Technologies® warrants its Commercial Grade products only to be free of any defects in materials or workmanship that would prevent them from functioning properly for two years from the date of purchase. This express warranty is extended by Cactus Technologies® Limited II. GENERAL PROVISIONS This warranty sets forth the full extent of Cactus Technologies®' responsibilities regarding the Cactus Commercial Grade Flash Storage products.
shall be tested to the product s functional and performance specifications. Upon confirmation of failure, each product will be analyzed, by whatever means necessary, to determine the root cause of failure. If the root cause of failure is found to be not covered by the above provisions, then the product will be returned to the customer with a report indicating why the failure was not covered under the warranty.