User Manual

21
9.1
9. Wireless Flash: Master
and Slave Modes
With a built-in Radio Frequency (RF)
module, the RF60X has the ability to
communicate with other RF60/RF60X
units wirelessly. To control and f ire
the RF60/RF60X wirelessly, set up one
RF60X in Master mode and the other
RF60/RF60X units in Slave mode.
Setting up the RF60X Slave
1. Make sure that the RF60X units
that you want to control through
t h e M a st er  a s h a r e s et t o
mode
(see Section 7.6).
2. Set the units to the same RF
channel (see Section 7.7).
3. Assign RF60X Slave units to either
group A, B, C, or D. Press
to select the group for each
RF60X. Each press of the Group
button in Slave mode will change
the group in the sequence of
A-B-C-D. The selected group will
be shown on the group panel.