User Manual

22
9.2
Commanding with the RF60X Master
1. Set the on-camera RF60X to
mode by pressing (se e
S e c t i o n 7.6).
2. Set the RF60X Master to the same
channel as the RF60X Slave units
(see Section 7.7).
3. Check the group statuses on
the group panel. Only activated
group(s) will be shown as A, B, C,
or D boxes.
Changing Parameters of the Master
Flash
4. On the RF60X Master, you can
change the power level and zoom
level of t h e M a ster  a s h it s elf,
a n d t h e R F60 X S l a v e  a s h e s i n
groups A, B, C, and D.
5. The default group is the Master
RF60X. In the display, the text
area will show <MASTER>. No group
is selected in the group panel,
though it still shows the group
activation status.