User manual

9. When the laser signal is once again detected by

the Sensor, the LED turns steady green and is ready for

the next shot when an object passes through the laser.

7.2.2 Multi Shot

LV5 triggers the camera to take multiple shots when laser

signal is intercepted.

1. Follow steps in Section 7.1.

2. Set the Sensor to Multi Shot.

3. Set the camera’s drive mode to burst/continuous/high

speed mode (refer to your camera user manual for

corresponding function key).

6. Aim the Emitter laser at the Sensor. When the laser is

detected, the blinking LED turns to a steady green and

the LV5 is ready to use. If the laser is never detected,

the LED continues to blink green every 3 seconds. Aim

again until the LED turns steady green.

7. PresstheTestButtonontheSensortoconrmthe

shutter cable or wireless connection with your camera.

At half-press, LED turns orange and camera will auto

focus; at full-press LED turns green, shutter

releases and the camera takes a shot.

8. When an object passes through the laser, the LV5

triggers the shutter of your camera and takes a shot

(delay may occur depending on camera model and lens

focusing speed).